Instructions to update bridge firmware using the Windows bootloader application.

This update to firmware rev. 3 will allow the bridge to work with an external router and network.
It also supports Art-Net 3 and sACN so that you can use the bridge with other lighting software.
If you don't need these, don't update your firmware.

1. Connect your Airstream DMX Bridge to your Windows PC with a USB cable.

2. After unzipping this folder on your PC, run the bootloader application "Airstream_Bridge_USB_Bootloader"
   directly from the new unzipped folder.

3. From the bootloader application, select and load the firmware file (Airstream Bridge xxx.cyacd) 
   that's included in the same folder.

4. Turn on the bridge, connect to it using the Airstream IOS app and put the bridge in bootloader mode -
   using the app select fixtures, touch "patch" then "bridge" then "bridge firmware" then touch the
   "Start Bootloader" button (bridge LED will flash).

5. Wait until the bootloader windows application shows "connected" the in lower right.

6. Click the "program" button on the bootloader application and wait until finished programming.

7. You might have to restart the bridge after the update is finished.